Set Up Instructions

Quick Start Guide

Before You Begin:

• Inspect the water hoses and accessories.
• Check for O-rings at both ends of the water hoses. If missing, locate them in the accessory kit and install them.

Connecting the Chiller & Tub:

• Prepare the Tub & Accessories:
• Your tub should either be empty for chiller setup or the water ports should be isolated with a valve.
• Use PTFE tape to create water tight seals by wrapping it around any male threaded connections.
• Install the adapters in the tub's water ports.
• Install the strainer at the water inlet of the chiller.
• Connect one water hose to the tub's inlet and the chiller's outlet.
• Connect the second water hose to the tub's outlet and the chiller's inlet.
• Final Check: Ensure all connections are secure. Check that the hoses are not kinked or pinched to ensure proper water flow and to prevent chiller alarms.

Fill the Tub:

• Before running or testing the chiller, fill the tub with fresh water until the water is above both the water inlet and outlet ports. If using isolation valves, open the valves now. Water should be able to freely flow into the hoses and up to the chiller.

Test the Chiller:

• Plug the chiller in. Before turning it on, press the test button. This is used to test whether the circuit breaker's leakage protection is working properly. After pressing the test button, the circuit breaker will simulate leakage in the circuit, the device will trip, and the light will go out. After it trips, press the reset button.

Let's Get Chilly!

Turn the chiller on using the power button located on the display. Water will now start circulating between the chiller and tub. After a few minutes, check if the filter house is full of water. If there is air inside, vent the housing by pressing the red button on top. If there are any leaks, use the white wrench to tighten the filter housing.